- ページ 2

計測機器 Ankom TDF23のPDF サービス手順をオンラインで閲覧またはダウンロードできます。Ankom TDF23 9 ページ。 Paddle bar replacement

Unplug the black 25 pin Cable Connector plug.

Twist counter-clockwise from the underside of the Electrical

Enclosure (right side from the front) and pull to release the

plug.

Unscrew the Shoulder Screw that connects the cable block

to the mixer piston.

Using the 1/8" Hex key wrench, unscrew the Shoulder

Screw on the Paddle Bar Assembly sticking through the hole

in the front of the instrument, connecting to the brass Rod

End of the Mixer Piston. Set the Shoulder Screw aside for

later use.

Unscrew the 4 screws holding the Paddle Bar Assembly

onto the front of the instrument.

a. Lift the instrument to its upright position.

b. Use the 5/32" Hex key wrench to remove the screws.

Be careful while doing this as the Paddle Bar Assembly

will fall out when the last screw is removed.

ANKOM Technology  2052 O'Neil Road  Email: [email protected] Phone: 315-986-8090  Fax: 315-986-8091

Paddle Bar Replacement

TDF

Service Procedure

Twist

& Pull

Shoulder

Screw

5/32"

Hex Key

Wrench

Hold

Left side

Paddle Bar

Hinge Post

TS021

Revised: 01/24/2017

pg. 2 of 9