計測機器 Ankom TDF69のPDF サービス手順をオンラインで閲覧またはダウンロードできます。Ankom TDF69 4 ページ。 Vacuum sensor installation

ページを印刷する

Remove panels.

a. Unscrew the six acorn nuts on the back of the

instrument and remove the clear back panel.

b. Unscrew the eight screws on the back of the

electrical enclosure and remove the stainless

steel (SS) panel.

Note: Using an Allen wrench, you may also

remove the top panel of the instrument to

improve visibility if necessary.

Remove the vacuum sensor cable tube.

a. Cut off the cable ties that secure the vacuum

sensor cable found on the left side inside the

instrument.

b. Loosen the nut that holds the plastic 1/4" cable

holder to the front panel of the instrument.

c. Detach the vacuum sensor cable from the

barbed fitting.



Remove the two service access screws

on the front of the instrument (right and

left side).



Gently tilt the instrument forward by

pulling the top of the electrical

enclosure forward and down.

instrument will pivot at its center. This

is done to allow for easier access to the

barbed fitting.



Detach the vacuum sensor 1/4" tube

from the barbed T-fitting that comes off

of the EtOH78 supply valve. This is the

barbed fitting that points upward when

the instrument is in its upright position.

ANKOM Technology  2052 O'Neil Road  Email: [email protected]  Phone: 315-986-8090  Fax: 315-986-8091

Vacuum Sensor Installation

TDF

The

SS panel to

electrical

enclosure

Acorn Nuts (the top two

are behind the black bar)

Cable ties

Nut

Service

access

screws

Vacuum

sensor

1/4" tube

T-fitting

013

Service Procedure

Revised: 07/16/2014

pg. 1 of 4