- ページ 7

DVR 247Security mDVR512のPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。247Security mDVR512 13 ページ。

4. EQUIPMENT TEST

When all of the cameras, cables, and add-on modules have been installed and when the DVR is connected to your

on-site laptop, the completed setup needs to be tested. To begin the test, ensure the DVR's Hard Drive lock is turned

to the locked position and then turn the vehicle's ignition to ACC or ON. Starting the vehicle's engine—and, by

extension, the alternator to charge the battery—during the test is not essential. Ensure that you have direct line-of-

sight to the front of the DVR to see the LED indicators.

Note: At the first sign of a hazard/malfunction (electrical fire, smoke) immediately turn the vehicle's ignition OFF.

The 500Series DVR boot sequence is as follows:

Time Elapsed

Sequence

[minutes : seconds]

0:05

0:15

0:20

0:45

0:50

1:00

247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com

The IGN (ignition) indicator will turn on. The DVR is idling in Stand-By

mode. It is not online or recording.

The PWR (power) indicator will turn on while the IGN (ignition) indicator

will flash, repeatedly. The power LED on the Hard Drive will turn on. The

DVR is now undergoing its boot sequence.

The green POWER indicator on the Event Marker will turn on. The DVR

cooling fan (four channel DVR's) will turn on.

The IGN (ignition) and PWR (power) indicators will turn on solidly. The DVR

has completed its boot sequence.

The Hard Drive activity light will flash, signifying that the drive is now

recording data.

The amber RECORD light on the Event Marker will turn on solid, also

indicating that the hard drive is recording data. The DVR is now ready to

record, or to be serviced through the Ethernet Cable from your laptop.

NOTE: A NEW FEATURE OF THE '09, 500 SERIES DVR'S IS THAT WHEN

THE X-CROSS CABLE IS CONNECTED TO THE DVR FOR CONFIGURING THE

BUS AND AIMING CAMERAS, THE UNIT WILL NOT RECORD, AS SOON AS

YOU DISCONNECT THE X-CROSS CABLE FROM THE DVR WITH-IN 10

SECONDS THE DVR WILL AGAIN BEGIN RECORDING.

Activity