- ページ 15
パワードライバー ANLIDAR MYTORQ MYBT-EP0612のPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。ANLIDAR MYTORQ MYBT-EP0612 19 ページ。 Automatic industrial cordless brushless power torque screwdrivers series
ページを印刷する4. Set up functions
Settings
1.
Auto learning
mode
P
+
S
2.
Connection to
wireless
controller
Up+Down
5. LCD、LED、BUZER status:
Screwdriver
status
Display current screw list U1-U9
SL
Display current OK fastening no. 1~99
SC
LCD displays OK when screwdriver is proper
OK
shut off each time.
LCD display will show NOK when error
NOK
occurred.
LCD will display OK ALL every time when a
OK ALL
batch completed.
When a batch complete, OKALL alarm will
At
trigger. Set alarm by sec.. (0.1~9.9)
->SL->SC->At->RC->SP->HC->LC->Ht->LT-->END
(Complete process)
Step1: Step1: Press P+S simultaneously for 5 sec., screen
will be flashing and greed LED will be on.
Step2: Start to set up functions step by step until shows HC,
use actual workpiece and screw to set up HC. (max.
fastening no. of thread)
Step3: When setting completes, press S to save settings.
Settings will be saved after screen flash 2 times.
Set up this function to connect to wireless controller
(MY-WSIO)
1. Default set as not connected. Press Up+Down
simultaneously for 10 sec. to change connection status.
2. To disconnect, press Up+Down simultaneously for 10 sec.
to disconnect
Description
Functions
Description
Green LED
Flicks
Red
LED Flicks
Green LED
Flicks
14
1. If no workpiece and
screw were not used
during HC setting. It
will auto save as 99.9
2. After HC settings
complete, HT and LT
will also be shown.
LED
Status
Power
Remark
Beep sound
1 short beep
sound
1 long beep
sound
1long beep
sound
Customize