- ページ 6

コントローラー ANLIDAR MYTORQ MYP40-1500のPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。ANLIDAR MYTORQ MYP40-1500 8 ページ。

The tool should be grounded while in use to protect the operator from electric shock. The tool is equipped with a

three-conductor cord and three-prong grounding-type plug to fit the proper grounding-type receptacle. The green

(or green and yellow) conductor in the cord is the grounding wire. Never connect the green (or green and yellow)

wire to a live terminal.

Green and yellow----- Earth

Blue

------ Neutral

Brown

------ Live

1. Use the controller voltage recommended in the specification of this manul.

2. When using a commercial power supply be sure to set up circuit and safety breakers.

You must also properly ground the mechanisms.

3. The temperature and humidity should be kept at appropriate levels.

4. Do not set up the power supply in a room that has poor ventilation and where it may be

exposed to dust and metallic flakes.

5. Do not put heavy object on top of power supply or pile thing on it.

6. Attach the power supply securely to a flat, stable surface. If the power supply is put a

high place, take special care to ascertain that there is no danger of it falling.

7. Keep bystanders away. Do not permit unauthorized personnel to operate this controller.

8. Do not set up the power supply near high voltage machinery or in an excessively noisy

environment.

9. Avoid setting up or storing the power supply in wet or oily environments or where it

might be exposed to corrosive or flammable gases.

10. We emphasize that the power supply should be placed in stable, fixed location.

he use of other than genuine Anlidar replacement parts may result in

decreased controller performance and increased maintenance, and may

invalidate all warranties.

Grounding Instructions

SAVE THESE INSTRUCTION

NOTICE