ミュージックペダル Becos CIQ-2 COMPIQ MINI PRO COMPRESSORのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Becos CIQ-2 COMPIQ MINI PRO COMPRESSOR 2 ページ。 For guitar & bass
Becos CIQ-2 COMPIQ MINI PRO COMPRESSOR にも: ユーザーマニュアル (2 ページ)

b
CIQ‐2 COMPIQ MINI PRO COMPRESSOR PEDAL 
MANUAL 
 
SPECIFICATIONS 
Input impedance: > 1MΩ 
Output Impedance: ~100Ω 
Ratio: 1:1 to inf:1 
Threshold: ‐40dB to +10dB 
Gain: ‐6dB to +20dB 
0dB input reference level: ‐20dBu (77.5mV) 
THD: <0.1% 1kHz, 0dBu in/out, 600Ω load, 24KHz BW, 12VDC power, 
through 6th harmonic 
Max Input Level: +5.5dBu 
Max Output Level: +5.5dBu 
Output frequency response: ‐2dB @ 40Hz; 0dB @ 100Hz ‐ 22KHz 
Optimal Power Voltage: 9‐12VDC ±10% Center Negative  
DC Power Plug: Ø 5.1/2.1mm, 12mm long Barrel 
Power Consumption: < 25mAh  
Product Size: Length: 39mm, Depth: 92mm, Height: 51mm 
Product Weight: 166 gr. 
Packed Weight: 186 gr. 
ADVICE, WARNING & CAUTIONS 
‐ Read this manual and keep it handy. 
‐ Do not place the pedal & batteries in direct sunlight, in extreme 
temperature and humidity conditions, or in dusty environment. 
‐ Do not make modifications to the circuit and do not install the 
pedal in any other way except as described in this manual. 
‐ As we struggle to improve ourselves and our products, we may 
change products specifications, design, and features without notice. 
Likewise, this manual may be changed or modified without notice so 
we advise you to download it from the website before using the 
product. 
INTRODUCTION 
Thank you for choosing CompIQ MINI Pro Compressor as your audio 
dynamic processing tool for your instrument.  
CIQ‐2  CompIQ  MINI  is  an  all  analog  studio  grade  compressor 
featuring  Ratio,  Threshold,  Make‐up  Gain  manual  controls, 
Soft/Hard  Compression  Knee  selector,  Auto  Adaptive  Attack  & 
Release  timings  which  respond  to  playing  dynamics,  and  Dry/Wet 
Mix control for a perfect blend of processed and clean signal. A true 
RMS‐level  detector  constantly  measures  input  signal  and  applies 
 
accurate  compression  through  a  transparent  sounding,  high 
performance  Blackmer®  VCA.  The  exact  amount  of  compression  is 
indicated by a 5‐LED display. 
EFFECT CONTROLS 
FOOTSWITCH  ‐  When  engaged,  the  switch  routes  the  audio  signal 
through the circuitry and Power LED is lit Green. When pushed again, 
the signal is routed in True Bypass from Input to Output, leaving the 
audio  untouched.  This  routing  is  still  available  even  when  pedal  is 
not powered. 
RATIO  ‐  This  control  sets  how  much  the  audio  signal  is  going  to  be 
compressed,  after  it  passes  above  the  set  threshold.  It  has  a 
continuous range starting from 1:1 (for one unit of input signal level 
you get one unit of signal output level; which means no compression 
is applied) and up to Infinite:1. At 9'clock, the control corresponds to 
2:1  ratio  ‐  a  mild,  musical  and  very  useful  compression,  which 
delicately evens out signal level jumps. At 12'clock it corresponds to 
4:1 ratio ‐ usually set when more compression feel is desirable, like 
when  playing  arpegiated  chords.  At  3'clock  it  corresponds  to  10:1 
ratio  ‐  a  rather  aggressive  compression,  which  may  be  desirable 
when note sustain is needed, or a country style music is played. After 
20dB  amount  of  compression,  the  amplitude  reduction  tends  to 
behave  like  Inf:1  ratio,  which  corresponds  to  Limiting  effect.  When 
used  as  limiter,  use  Threshold  control  to  set  the  level  after  which 
compressor will act like a limiter, and set Ratio above 10:1. Keep in 
mind that the more compression is applied, the more make‐up gain 
is needed, which results in a normal increase of noise.  
THRESHOLD  ‐  This  control  sets  the  signal  level  after  which 
compression is applied. Compression is only applied to the portion 
of signal that goes above the threshold. Set very low, it makes the 
compression  kick  in  immediately  even  for  small  input  signals.  Set 
higher, it lets a good portion of the signal untouched. This is a very 
powerful  control,  because  it  allows  the  compression  to  affect  only 
higher  strokes  of  signal,  while  leaving  the  meat  and  bone  of  audio 
untouched.  This  also  translates  into  a  greater  sound  transparency 
and  an  increase  in  output  level,  making  some  make‐up  gain  (or 
mixing Dry/Wet signals) totally unnecessary, which, in turn, reduces 
amplification  noise  at  the  output.  Because  of  the  50dB  threshold 
range, CompIQ can accommodate a wide range of audio signals from 
electric  instruments.  With  an  appropriate  preamp,  it  may  be  used 
even  with  vocal  or  instrument  microphones.  When  Threshold  is  set 
higher, CompIQ can be used with studio line level signal.  
MAKE‐UP  GAIN  ‐  Because  compression  means  lowering  the  output 
signal,  some  recovery  gain  is  needed,  to  match  output  with  input 
level.  The  more  compression  is  applied  (higher  compression  ratio), 
the  more  recovery  gain  has  to  be  dialed  in  to  compensate.  Be 
aware  of  the  fact  that  at  higher  compression  ratios,  the  recovery 
circuit must re‐amplify a very low signal and with amplification, more 
noise  is  introduced.  To  overcome  this,  we  strongly  advise  using 
Threshold,  setting  lower  compression  Ratios.  Ultimately,  blend  in 
 
some dry signal with the Mix control. However, it makes no sense to 
over  compress  a  signal  at  low  thresholds  just  to  recover  its  gain 
afterward, and increase output noise resulted from amplification. 
DRY/WET MIX ‐ This control acts like an audio mixer, where you can 
blend  input  clean  signal  with  the  output  compressed  signal.  This 
helps  restore  some  transients  or  some  squished  frequencies  which 
are  less  perceived  by ear,  because  they  are  reduced  to  lower  level, 
after compression. When the trimmer is set in the middle, the mix is 
50‐50.  Such  a  setting  washes  out  a  lot  of  compression  feel,  and 
make‐up gain must be dialed in to preserve the dynamic processing 
feeling.  The  dry  signal  is  a  perfect  replication  of  the  input  signal. 
When set to 100% dry, CompIQ MINI acts like a buffer. 
SOFT/HARD  COMPRESSION  KNEE  ‐  Rarely  available  in  compression 
pedals,  this  control  multiplies  the  compression  flavors  that  can  be 
achieved.  The  Hard  Knee  compression  is  evident  and  the  ear  will 
perceive  the  dynamic  processing  easily.  Once  signal  gets  above 
threshold, compression kicks in with a sharp corner, and with higher 
compression ratios it makes the limiting effect obvious ‐ a desirable 
setting for chic'n'pickin or country playing style. With lower ratios, it