- ページ 3

アクセサリー Druck UNIK5600のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Druck UNIK5600 8 ページ。 Marine approved

1. INTRODUCTION

•

This manual contains the removal and installation procedure for the backend of the

demountable KYNAR cable and demountable TPE-U cable version of the UNIK5600/5700.

•

Read the whole installation procedure before starting installation. The technical specification

is detailed in the datasheet.

2. CAUTIONS

•

All the operations described in this manual should only be performed by trained and

authorized professionals.

•

Always wear the necessary personal protective equipment when completing this procedure.

WARNING

explosive atmosphere is present - THIS CAN CAUSE AN EXPLOSION. Isolate the

power supply to the equipment first.

3. INSTALLATION

3.1 Accessories & Tools Preparation

•

Torque wrench (1.8 Nm)

•

2.5mm Hexagon bit

•

O-ring (163M2956-1)

Remove the screws and spring washers.

Separate the flange and unplug the connector. Make sure the flying leads are not pulled out

from the connector.

Do not complete this procedure in a hazardous area while an

English–UNIK5600/5700 Demountable Backend Exchange Manual | 1