- ページ 9

ラボラトリー機器 Drucker Diagnostics 642EのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Drucker Diagnostics 642E 16 ページ。
Drucker Diagnostics 642E にも：取扱説明書 (8 ページ)

j) Fasten the guard bowl to the base with six 5/32 nominal diameter, low-profile head

rivets.

k) Install the exhaust air cover with three 5/32" rivets. Make certain that the motor wire

harness is contained within the cover's wire channel. See fig 2.

l) Replace the zip tie removed earlier

m) The lower assembly is complete.

6.13 Power Connections and Final Assembly

IMPORTANT: These steps must be followed to avoid personal harm and to avoid

damaging the PCB.

a) Make certain that the lower assembly is unplugged from the mains supply.

b) Connect the motor/power connector to J5 on the PCB

c) Carefully place the cabinet onto the base taking care not to pinch any wires between the

two.

d) Complete the assembly by replacing the six #8 screws, washers and lock washers with a

#2 Phillips driver.

DRUCKER DIAGNOSTICS

MODEL 642E SERVICE MANUAL

Fig 2

SM006

REV: A