- ページ 3

GPS DRUID Debut FLEXのPDF クイックスタートをオンラインで閲覧またはダウンロードできます。DRUID Debut FLEX 4 ページ。 Cellular

Before deployment, it is highly suggested to keep the device working for several days. During the

period, you can get familiar with the system, get to know the best device setting for local

environment and be sure the battery is fully charged before deployment.

We will give you in-time technical support during testing and deployment to ensure the device

can work at its best performance.

Alternative Method for Turning-On

Some models can also be turned on/off by magnet. If you have already initialized

your devices, you can also use magnet for turning on. The method is described

below:

Place the magnetic switch close to the blue dot as shown below for at least 5

seconds. The green LED light blinks for 3 seconds and goes out, and the device is

turned on.

Debut FLEX

However, this method might not give you accurate feedback. For example, the LED

blinking pattern might not be obvious in daylight, and the App does not have an

updated record about device on/off status and battery level. So, unless you are very

familiar with Debut devices, we suggest you to always use App for turning on.

Another thing to note is that when you use magnet to turn off devices, all data stored

on board will be erased, as well as the fine settings. So, if you turned off a device

with magnet, you should initialize it again with App before you deploy it on animals.

Debut FLEX II

Debut LEGO