- ページ 18

水ポンプ Annovi Reverberi AR 115/1000 bpのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Annovi Reverberi AR 115/1000 bp 20 ページ。
Annovi Reverberi AR 115/1000 bp にも：マニュアル (17 ページ)

ページを印刷する

MAINTENANCE INSTRUCTIONS

Lengthy pump lay-offs

It is important to comply with the recommendations for lay-offs in the operator's manual of the machine into

which the pump is incorporated.

For the pump itself, at the end of pumping operations it is essential to flush out the internal circuit by pump-

ing clean water. After this, open the intake circuit to the air and leave the pump in operation until the internal

circuit is completely empty. Following this simple procedure at the end of every operating session will prevent

the retention inside the pump of products which are often corrosive and may damage its hydraulic circuit in

the long-term.

If the pump is laid off during the winter in locations with severe weather conditions, it is very important to flush

out the internal circuit as described above and then draw diluted automotive anti-freeze into the pump. Then

take care to discharge the liquid from the system and the pump in particular; it usually has a specific drain plug.

Putting the pump back into service

Before putting the pump back into service after a long period out of use, check the oil level and the tightness

of the mounting screws.

Scrapping the pump

Used units must be disposed of in compliance with local legislation.

English language

Use and Installation