ページを印刷する■ Battery and Charging
1. Please read this manual and safety rules thoroughly before using the Lithium
battery pack.
2. The battery pack capacity should be lower than 50% when being transported
according to transportation rules. Charge for 12 hours with the charger
supplied before the first use.
3. Please charge with the charger supplied by original manufacturer. Do not use
third party chargers
4.
Battery will drain during long periods of disuse.
(Battery switch should be set to "on" while charging. The battery pack can be charged while installed
or removed from the bicycle)
1. Charging Steps
Plug the power plug of the charger into power source.
The charger's LED indicator light will be green (as DWG 1).
Connect the charger output to the battery pack input. After 1 the LED indicator
of the charger will change to orange, (as DWG 2).
When LED indicator changes to green light, the battery pack is fully charged.
Power-off protection will start automatically and the light will extinguish (as
DWG 3). Total charge time will be about 3~4 hours. An initial charge of 12 hours
is required before the first use.
After lithium battery pack is fully charged, disconnect the charger from the
battery and pull out the power cord from the socket. Proper charge temperature
is 0~45 degrees Celsius.
1
CAUTION
2
9
Switch
Charging Seat
Battery Lock
Battery Output Terminal
3