- ページ 10

アンプ Absolare Push-PullのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Absolare Push-Pull 15 ページ。
Absolare Push-Pull にも：ユーザーマニュアル (14 ページ)

6. Operating the Unit

Before turning on each Absolare Push Pull Mono Amplifier, be sure that all tubes are

installed and all cables connected correctly.

If you have changed 845 output tubes you should first minimize the bias settings (by

rotating to counter-clockwise) before turning-on the amplifiers and re-adjust the bias

settings. Please refer the bias settings section (6.2.1).

After turning each Amplifier on, the power indicator LED on the front face plate will

start to blink. You will not hear any sound until the indicator LED stops blinking to

illuminate continuously which indicates all the capacitors are charged and internal

voltages are stabilized.

Absolare Push-Pull Mono Amplifiers will be ready to operate approx. 40 seconds

after turning on the power and attain full sonic performance in 15 to 30 minutes.

Measurement points for the bias levels are at the back panel:

ABSOLARE Push-Pull Mono Amplifier User Manual 1.2