- ページ 12

電源 Anolis ArcPower 72/K2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Anolis ArcPower 72/K2 20 ページ。

8.Control board

The control panel situated on the top cover of the ArcPower 7/K allows DMX addressing,calling Built-in pro-

grams and setting the fixture behaviour

Control elements:

[ENTER] button- enters menu,confirms adjusted values and leaves menu.

[UP] button and[DOWN] button- moves between menu items on the the same level, sets values.

In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.

After switching on the ArcPower 7/K ,the display shows the initial DMX address:

Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].

8.1 Addressing the ArcPower 72/K2

The fixture can be operated in the two modes:DMX mode-fixture is controlled via DMX 512 by an external

For DMX mode, it is important to define the starting DMX address from which the ArcPower 72/K2 will respond

to the DMX controller

Setting the DMX start channel for DMX operating:

1. Connect ArcPower 7/K to the mains.

2. Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres

"001".Confirm by pressing [ENTER] button and "001" will start to flash frequently.

3. Use the [UP] and [Down] buttons to select the desired address.

4. Confirm by pressing [ENTER].

After having addressed ArcPower

ler.

By entering this menu a complete overview of all programs is offered,from which the program to be run can be

selected by pressing [ENTER].Selected program runs in a loop.The fixture includes 6 built-in programs (P.01-

P.6) and 3 free editable programs (E.P.1-E.P.3),each up to 30 steps.

If item "AUt" is On,the fixture in DMX mode will remember last running program and this program will run after

switching on the fixture.

Each program step has a fade time - the time during which effects go to the current step and a Standing time-

-the time,during which effects last in the current step.

DMX controller

Stand-alone mode - fixture uses Built-in programs and is

able to control other fixtures in the master/slave chain.

See the chapter "Stand-alone mode" for detail description.

7/K,

you may now start operating ArcPower 7/K via your DMX control-