- ページ 2

室内装飾品 Anova F1110のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。Anova F1110 2 ページ。 Children's square table

ページを印刷する

3. Place one of the Table Legs next to the tabletop

frame support as shown. When viewing down

the frame support from the outside of the table,

the Leg should go on the right side of the frame

support. Put a Washer on one of the 1.25" long

Bolts and insert the Bolt through the Leg and

frame support with the bolt head toward the

outside of the Tabletop. Install a Washer and

Nut to the Bolt and hand tighten, leaving the

Nut finger-tight. Repeat this step for each of

the three remaining Legs.

4. After all the Legs are attached (only two are shown

here for clarity), install the Cross Brace. Put a

Washer on one of the 2.25" long Bolts and insert

the Bolt through the Leg and Cross Brace with

the bolt head toward the outside of the Tabletop.

Install a Washer and Nut to the Bolt and hand

tighten, leaving the Nut finger-tight. Repeat this

step for each of the three remaining Legs.

5. Use a Rubber Mallet or Hammer to seat the

Plastisol Plugs into the holes on the bottom of

each Leg.

6. Position a Seat upside-down next to one of the Legs as shown. The leg brackets attach to the

outside of each of the seat frame cross-members. Put a Washer on one of the 1.25" long Bolts

and insert the Bolt through the leg bracket and seat frame cross-member with the bolt head

toward the outside of the Seat. Install a Washer and Nut to the Bolt and hand tighten, leaving

the Nut finger-tight. Repeat this step for each of

the three remaining mounting holes in that Seat.

Install the three remaining Seats in the same

manner.

7. Turn the table right side up and tighten the table

frame hardware while checking with a Level;

minor adjustments can be made while tightening

the hardware to make the Tabletop level.

8. Tighten the hardware on each of the seat frames

while checking the Seat with a Level; minor

adjustments can be made while tightening the

hardware to make the Seat level.

9. Retighten all hardware two weeks after initial

assembly.

•

Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,

missing, or broken hardware, and general instability.

•

Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.

wArnInG

•

Repairs must be made using only factory authorized parts and methods.

CAre And

•

Do not drag the assembled unit across any surface.

mAInTenAnCe

•

This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to

remove surface dirt. Do not clean with a solvent or petroleum based products.

211 No

St. Louis, MO 63141

rth Lindbergh Blvd.

Washer

Tabletop

Frame

Insert

Plugs

Washer

tel: 888.535.5005

web: anovafurnishings.com

Leg

Washer

Nut

Bolt

Leg

Washer

Nut

Cross

Bolt

Brace

Leg

Bracket

Washer

Nut

Bolt

Seat Frame

10/2012