- ページ 11

電動工具 Drytac HOT PRESS HGP220のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Drytac HOT PRESS HGP220 19 ページ。 Heated glass top vacuum press
Drytac HOT PRESS HGP220 にも：取扱説明書 (19 ページ)

ページを印刷する

HOT PRESS USERS MANUAL

FUNDAMENTALS OF DRYMOUNTING

Dry mounting an image to a substrate can be performed in a variety

of ways and varies according to the nature of the mounting substrate,

mounting adhesive and the print, photo or artwork being mounted.

However, the basic methods described below will provide excellent

results for most standard applications.

1. Set the vacuum press to reach an operating temperature of

185°F (85°C)*.

2. Cut a piece of dry mounting tissue slightly larger (on all sides)

than the work to be mounted.

3. Place your print face down onto a clean work surface and

cover with the dry mounting tissue. Lightly tack the tissue to the

back of the print with a tacking iron. To avoid adhesive build-

up on the tacking iron, tack through silicone release paper/ﬁ lm,

shiny side toward the tissue. Trim the excess tissue.

4. Place the print, with the tissue attached, onto the mounting

substrate. Lift the opposite end of the print/mounting tissue

and tack the mounting tissue side directly onto the mounting

substrate.

5. Place the three components into the press between two

sheets of release paper/ﬁ lm for approximately 30 seconds to

3 minutes*– from the time the press has achieved the desired

pressure setting.

* Your actual settings will vary according to the size of the press, type

of dry mounting tissue, the type of mounting substrate, the artwork

material used (in terms of material and the size of the print). See

individual product speciﬁ cations for recommended dwell times.

Note: Clear release ﬁ lm or silicone release paper must be placed on

top of the "mounting package" to prevent any exposed adhesive from

sticking to the glass.

Illustration 11A: Top to bottom material

placement order in press

PROCESSING TIPS:

• Maximum vacuum pressure is

• We recommend silicone coated

• The diagram in Illustration 11A

Illustration 11B: Tacking dry

mounting components

Mounting

recommended - except when

mounting onto foam board, as this

type of substrate may be subject

to "crushing". When mounting

onto foam board, we recommend

using reduced vacuum pressure

during the mounting cycle.

clear release ﬁ lm over silicone

release paper. Clear release ﬁ lm

is transparent (allowing you to

see the work in progress), less

prone to "creasing" and has a

longer usage life.

shows the positioning for each

component in the dry mount

package prior to being placed in

the press.