- ページ 10

電動工具 Drytac HOT PRESS HGP260のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Drytac HOT PRESS HGP260 19 ページ。 Heated glass top vacuum press
Drytac HOT PRESS HGP260 にも：ユーザーマニュアル (19 ページ)

ページを印刷する

ADJUSTING THE TEMPERATURE CONTROLLER (FARENHEIT)

To adjust the pre-set temperature, press and hold Button1. Then use Button 2 to increase or

Button 3 to decrease the pre-set temperature. Once the desired level is reached, release Button 1

to set the desired temperature.

When current is flowing through the heating element, a small red dot next to OUT1 will glow. In

normal operation, the dot will turn on and off every few minutes as the controller maintains the

glass at the preset temperature.

At the factory, the temperature controller is set to allow a maximum temperature of 239° F. The

factory preset temperature is 194° F.

Illustration 8A: Temperature Controller (F)

ADJUSTING THE TEMPERATURE CONTROLLER (CELSIUS)

To adjust the preset temperature, press Button 1 and L1 will appear for one second. Then press

Button 3 to increase or Button 4 to decrease the preset temperature. Once the desired level is

reached, press Button 1 to set your required temperature.

When the current is flowing through the heating element, a small red dot next to RL1 will glow. In

normal operation, the dot will turn on and off every few minutes as the controller maintains the

glass at the preset temperature.

At the factory, the temperature controller is set to allow a maximum temperature of 115° C. The

factory preset temperature is 90°C.

Should you press Button 4 in error and HY1 displays, just press Button 1 again. Do not change

the value that follows HY1.

OPERATING THE VACUUM PUMP (Timer)

Automatic Control

For automatic control, the pump switch should be set in the AUTO

position. The Timer controls the length of the cycle in minutes and

seconds.

The Timer has three operating modes:

•

Set – Normal mode. The timer is ready to operate.

•

Pgm – Program mode. 6the preset time may be changed.

•

Hand – Manual mode (see "Manual Operation") below.

When in Set mode, the timer displays the preset time.

Illustration 8B: RL1 Dot