- ページ 9

モニター 3M 725のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3M 725 16 ページ。 Wrist strap monitor
3M 725 にも：取扱説明書 (15 ページ)

SECTION 4

Installation Under Work Bench

The 3M

Wrist Strap Monitor Model

™

725 can be mounted under a work bench

by securing with two #8 screws (not

supplied) through the mounting hole

tabs located on the top cover.

When mounting the Wrist Strap Monitor

Model 725 under a work bench for non

mobile use, remove the parking clip

(Section 6) from the Wrist Strap Monitor

Model 725 using a small screwdriver.

The Wrist Strap Monitor Model 725 is

now ready to mount.

Position the monitor so that it is

convenient for the operator to plug

their wrist strap ground cord into the

jack on the front of the monitor. It is

recommended that the front face of the monitor be flush or slightly recessed

from the front edge of the work bench. Attach the monitor to the work bench

with the screws. It may be necessary to pre-drill pilot holes for the screws.

Attach the dual conductor ground clip or each wire of the monitor's dual

conductor ground cord to a suitable ground.

Use of an optional 3M

of the monitor's input jack. The user disconnects the wrist strap ground cord

from the wrist band and plugs into the Stand-By Jack 3057 which is mounted at

the work station. Plugging into the Stand-By Jack 3057 prevents the Wrist Strap

Monitor Model 725 from continuously alarming when disconnected from the

wrist band.

The system is now ready for use.

Stand-By Jack 3057 at the work station extends the life

™

Figure 4

Note: Use of the monitor in this way precludes

grounding a work surface through the snap

connector on the bottom of the monitor. A static

control work surface, if present, would require

grounding separately through an additional

ground cord.