- ページ 7

炉 DS Greenhouse Blast GH450のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DS Greenhouse Blast GH450 13 ページ。 High efficiency wood or coal furnace

DS Pneumatic Powered Thermostat Kit

This thermostat is designed for use with a wood or coal furnace only. It will not take the place of proper furnace

management. You will get the best response from this unit if you service your furnace according to the manu-

facturers recommended practices, Your Air Supply needs to be clean and dry.

Installation Instructions

A - Install cylinder approx. 24" above and center of draft inlet lid with #14 x 3/4 self drilling screws. Fasten chain

with no slack when cylinder is extracted.

B - Mount air regulator and thermostat 50 – 70 feet from furnace.

C - Connect 5/32 air hose from regulator to "in" on thermostat. Then from "out" of thermostat to cylinder at

furnace as per diagram. Air regulator needs to be set at 20psi.

D - Test the unit after installed to make sure draft lid opens and closes properly. Then build your fire in furnace,

and set thermostat to desired temperature.

Air Regulator

set at 20psi

Air Supply

5/32 Air Hose

DSM61236NH . . . . . .5/32 Nylon Hose

DSMIUHH2 . . . . . . . .Thermostat

DSMAR2000-02 . . . . .Air Regulator

DSMK4515 . . . . . . . . .Gauge for Air Regulator

DSM75RSR . . . . . . . .Cylinder

DSMCLEVISKIT . . . . .Clevis Kit for Cylinder

DSMMOUNTBKT . . . .Mount for Cylinder

DSMCYLFITTING . . .Push-Lok fitting for Cylinder

Thermostat

50 - 70 feet

from Furnace

5/32 Air Hose

Mount

Cylinder

on side of

Furnace

Attach Chain to

Draft Inlet at

side of Furnace

24"

Chain