- ページ 2

ウォーター・ディスペンサー DS Services of America Pure Water Dispenser 200 SeriesのPDF 掃除の仕方をオンラインで閲覧またはダウンロードできます。DS Services of America Pure Water Dispenser 200 Series 2 ページ。

ページを印刷する

Fig 5

Fig 6

Fig 7

Load water

bottle FIRST.

Dispense

water from

hot and cold

faucets.

THEN turn on the

hot tank switch.

Carefully pour hot water into the reservoir until it is ¾ full (Fig 5). Let the water

sit for 5 minutes. Always use caution when handling hot water.

Wearing disposable non-latex gloves, wipe the inside of the reservoir with a clean

cloth or soft brush. Use caution as the water may still be hot to the touch (Fig 6).

Completely drain the water from the reservoir by dispensing the water through

the hot and cold spigots into a container.

Repeat steps 6 and 8 to completely flush the dispenser. It is not necessary to wipe

the inside of the reservoir a second time.

10. Replace the separator and close the cover (Fig 7). Wipe down the cooler and the

surrounding area to dry any water spills.

11. Wash your hands thoroughly with soap and water for at least 20 seconds. Install

a full water bottle on the dispenser. Dispense water through the hot and cold

spigots. Turn on the hot tank heater switch located at the rear of the

dispenser.

WARNING:

spigots before turning on the hot tank switch. Failure

to follow proper installation instructions may cause

damage to water dispenser.

Dispense water through the hot and cold