- ページ 7

アンプ DS18 HOOLIGAN KO H-K02のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DS18 HOOLIGAN KO H-K02 13 ページ。 Competition spl monoblock; class d

It is advisable to test the ground with an ohmmeter between the ground cable and

the negative battery cable to ensure a good low resistance connection. Some

allows used in modern cars do not offer the best ground. If you believe this is the

case - first consult with the vehicle manufacturer.

Run the speaker wire to the speakers. It is advised that you leave some

extra wire at this point. You can fix it later.

If you haven't done so already, mount the amp now.

Connect the power and ground to the amplifier.

ONLY AFTER THIS STEP - SHOULD YOU INSTALL THE FUSE AT THE BATTERY.

Connect the remote wire from the head unit to the amplifier.

Now is a good time to turn on the amp for the first time. Make sure it turns

on properly and does not go into protection mode.

Connect the speaker wires to the amp and speakers (make sure the amp

is off first). Make sure the polarity (+) and (-) is correct.

10. Connect the RCA's to the amp.

11. Double check the amplifier controls at this time. Make sure everything is

set correctly for your system.

12. Now you're ready to play it for the first time. It is best to leave the gain all

the way down at first. Start with the head unit volume low and work your

way up.

13. Now you can tune the amp. Take your time and make only one

adjustment at a time. It may take some time to get the system fully

adjusted. During this time the amp is drawing current from the battery. You

should check the battery voltage from time to time and recharge it, if it

gets low. That's it. You're done.

Now have fun.

IT LOUD