- ページ 2

照明器具 Daisy Below Ground Pool Cover BoxのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Daisy Below Ground Pool Cover Box 4 ページ。
Daisy Below Ground Pool Cover Box にも：インストレーション・マニュアル (3 ページ)

ページを印刷する

INSTRUCTIONS

Prepare dig zone by removing

pavers if being installed into

pre paved area.

Dig trench to minimum of

550mm wide and 555mm deep

(BGB) or 400mm wide and

410mm deep (BGB Small) and

at least 300mm past either side

of the pool's waterline edge. For

example, if pool is 4000mm wide

dig trench 4600mm long.

If space is restricted on one side, place box at least

100mm past the pool edge or as far as possible if pool

wall is on a boundary. Please ask us for advice on

placement in restricted space circumstances.

Once trench is dug to correct

size and depth, place concrete

slabs at each end where angle

braces are located on the box

(approx. 1000mm – 1200mm

from end of box).

Level these slabs so they are approx. 512-515mm

(BGB) or 356-360mm (BGB Small) below the finished

height of paving or concrete. Place spirit level on pool

headers and lay across the trench propping the other

end up so spirit level is level. Using the level, measure

down to the slabs to obtain correct depth of slab. Use

rubber mallet to tap down to bed slab in.

Once both slabs are in place and at correct level, place

for sufficient drainage, blue metal or aggregate along

the trench making sure you do not exceed more than

50mm above the slab height, for boxes with a centre

brace or braces leave a small amount out so brace

doesn't touch the blue metal.

NOTE: Take note of site and soil drainage requirements. Extra (sub soil)

drainage may be required to take water away from the BGB. If there is

not sufficient drainage the BGB will fill with water.

Once blue metal is down you

are ready to place box into hole.

Carry box to the trench edge,

place rope or straps under each

end of box and use these to lift

and lower into hole.

Note: Ensure correct orientation – lid

opens towards pool

With box in the hole and end

braces are sitting on concrete

slabs level box up to required

height via the 4 bolts inside

the box, screw all 4 down so

they touch the concrete slabs

and then every 1 turn gives you

approx. 1mm of lift. Make sure

cover does not touch bolt head.

Once box is level, measure

the distance away from pool

headers so they are the same

either side (within a couple of

millimetres).