- ページ 10

セキュリティシステム DSC PC1575RKのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DSC PC1575RK 20 ページ。 Tyco digital security control instruction manual

Viewing Trouble Conditions

The control panel continuously monitors a number of possible trouble conditions. If one of these

trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the

keypad.

Troubles can only be viewed when the system is in the disarmed state. If a trouble occurs while the

system is armed, enter your access code to disarm the system, then follow the procedure outlined

below to determine the specific trouble.

NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your

installing company for service.

To view troubles from an LED Keypad:

A trouble will be indicated by the Trouble light which will remain ON until the trouble condition is

cleared. If you cannot determine the cause of the trouble condition, contact your installer for

assistance.

To view the type of trouble condition, press [ ][2]. A one or more zone lights will turn ON, indicating

the various trouble conditions:

ZONE LIGHT

TYPE OF TROUBLE

1 ................. Service required. Call your installation company for service.

2 ................. Indicates the loss of AC power. When this trouble occurs, the Trouble light will turn

ON but keypad buzzer will not sound.

3 ................. Communications troubles Press [3] either or both of zone lights 1 and 2 will be ON,

indicating the following communication troubles:

1. Telephone line trouble

4 ................. Zone fault. Press [4] and the zone light(s) corresponding to the faulted zones will turn

ON.

5 ................. Zone tamper. Press [5] and the zone light(s) corresponding to the tampered zones will

turn ON.

6 ................. Loss of time on system clock. To set the system time, following the instructions in

"Setting System Date and Time" on page 11.

To view troubles from an LCD Keypad:

From the Ready state, use the arrow (< >) keys to scroll to the following message.

Press [ ] [2] key to view the trouble. The message will read...

System Trouble

(*2) to View <>

Use the arrow (< >) keys to view which troubles are present on the system. Once

View Trouble <>

you have scrolled through the list of troubles, this display will read...

"Trouble Message"

Press the [#] key to exit the Trouble Viewing mode and return to the Ready state.

2. Failure to communicate