- ページ 16
ネットワーク・ハードウェア Foxconn RPQN O-RUのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Foxconn RPQN O-RU 18 ページ。 Local 5g nr system
ページを印刷する
Foxconn
RPQN O-RU Installation and Operating Guide
5.5 Can I add a Switch to connect O-RU and O-DU?
Yes. Please make sure following items:
● The L2 switch should support VLAN with tag.
● Those ports (connected to BBU and RU) should be in trunk mode
● Both VLAN 1 and VLAN 2 should be in those trunk ports
● Should keep VLAN tag in those ports (DO NOT set untag)
● Enable jumbo frames. Set frame size more than 9000 Bytes.
Figure 36 O-RU O-DU connectivity with Switch and GM
5.6 How to enable Auto boot up.?
If you want to make RU running when reboot without re-execute
O-RU Operating instruction for V2 firmware_v1.0
lines into /home/root/test/test.sh to configure IP and launch CU plane:
if
[ $(tty) =
"/dev/ttyS0"
./set_qse.sh 100
./init_rrh_config_enable_cuplane
fi
● How to change configuration after enabling auto boot up?
○ If you
can
i. Make changes in RRHconfig_xran.xml.
ii. Running /home/root/test/reboot.sh
○ If you
can not
i. Connect to O-RU via the USB Serial Port.
ii. Unplug Power cord and plug again.
iii. Once the prompt is shown, press "Ctrl+C" to stop the running process.
iv. Make changes in RRHconfig_xran.xml.
v. Running /home/root/test/reboot.sh
● How to disable auto boot up?
○ Just remove or mark the above command in /home/root/test/test.sh.
Version: v2.7
];
then
# 100 depends on your subnet setting
remote SSH to O-RU with account/passwd : root/root
remote SSH to RRH, you can
[RP0-417] Foxconn RPQN
setting Step.6 and Step.7, please add below
16