- ページ 11

セキュリティシステム DSC PC51O2-433NAのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DSC PC51O2-433NA 13 ページ。

ページを印刷する

WARNING Please Read Carefully

Note to Installers

This warning contains vital information. As the only individual in contact with

system users, it is your responsibility to bring each item in this warning to the

attention of the users of this system.

System Failures

This system has been carefully designed to be as effective as possible. There are

circumstances, however, involving fire, burglary, or other types of emergencies

where it may not provide protection. Any alarm system of any type may be

compromised deliberately or may fail to operate as expected for a variety of

reasons. Some but not all of these reasons may be:

I I I I I Inadequate Installation

A security system must be installed properly in order to provide adequate

protection. Every installation should be evaluated by a security professional

to ensure that all access points and areas are covered. Locks and latches on

windows and doors must be secure and operate as intended. Windows, doors,

walls, ceilings and other building materials must be of sufficient strength and

construction to provide the level of protection expected. A reevaluation must

be done during and after any construction activity. An evaluation by the fire

and/or police department is highly recommended if this service is available.

I I I I I Criminal Knowledge

This system contains security features which were known to be effective at the

time of manufacture. It is possible for persons with criminal intent to develop

techniques which reduce the effectiveness of these features. It is important that

a security system be reviewed periodically to ensure that its features remain

effective and that it be updated or replaced if it is found that it does not provide

the protection expected.

I I I I I Access by Intruders

Intruders may enter through an unprotected access point, circumvent a sensing device,

evade detection by moving through an area of insufficient coverage, disconnect a

warning device, or interfere with or prevent the proper operation of the system.

I I I I I Power Failure

Control units, intrusion detectors, smoke detectors and many other security

devices require an adequate power supply for proper operation. If a device

operates from batteries, it is possible for the batteries to fail. Even if the batteries

have not failed, they must be charged, in good condition and installed cor-

rectly. If a device operates only by AC power, any interruption, however brief,

will render that device inoperative while it does not have power. Power

interruptions of any length are often accompanied by voltage fluctuations which

may damage electronic equipment such as a security system. After a power

interruption has occurred, immediately conduct a complete system test to en-

sure that the system operates as intended.

I I I I I Failure of Replaceable Batteries

This system's wireless transmitters have been designed to provide several

years of battery life under normal conditions. The expected battery life is a

function of the device environment, usage and type. Ambient conditions such

as high humidity, high or low temperatures, or large temperature fluctuations

may reduce the expected battery life. While each transmitting device has a

low battery monitor which identifies when the batteries need to be replaced,

this monitor may fail to operate as expected. Regular testing and maintenance

will keep the system in good operating condition.

I I I I I Compromise of Radio Frequency (Wireless)

Devices

Signals may not reach the receiver under all circumstances which could include

metal objects placed on or near the radio path or deliberate jamming or other

inadvertent radio signal interference.

I I I I I System Users

A user may not be able to operate a panic or emergency switch possibly due to

permanent or temporary physical disability, inability to reach the device in

time, or unfamiliarity with the correct operation. It is important that all system

users be trained in the correct operation of the alarm system and that they

know how to respond when the system indicates an alarm.

I I I I I Smoke Detectors

Smoke detectors that are a part of this system may not properly alert occupants

of a fire for a number of reasons, some of which follow. The smoke detectors

may have been improperly installed or positioned. Smoke may not be able to

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modifications not expressly approved by Digital

Security Controls Ltd. could void your authority to use this equipment.

This equipment generates and uses radio frequency energy and if not installed

and used properly, in strict accordance with the manufacturer's instructions,

may cause interference to radio and television reception. It has been type tested

and found to comply with the limits for Class B device in accordance with the

specifications in Subpart "B" of Part 15 of FCC Rules, which are designed to

provide reasonable protection against such interference in any residential

installation. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to television or

radio reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the

following measures:

firealarmresources.com

reach the smoke detectors, such as when the fire is in a chimney, walls or

roofs, or on the other side of closed doors. Smoke detectors may not detect

smoke from fires on another level of the residence or building.

Every fire is different in the amount of smoke produced and the rate of

burning. Smoke detectors cannot sense all types of fires equally well.

Smoke detectors may not provide timely warning of fires caused by

carelessness or safety hazards such as smoking in bed, violent explo-

sions, escaping gas, improper storage of flammable materials, overloaded

electrical circuits, children playing with matches or arson.

Even if the smoke detector operates as intended, there may be circum-

stances when there is insufficient warning to allow all occupants to escape

in time to avoid injury or death.

I I I I I Motion Detectors

Motion detectors can only detect motion within the designated areas as

shown in their respective installation instructions. They cannot discrimi-

nate between intruders and intended occupants. Motion detectors do not

provide volumetric area protection. They have multiple beams of detec-

tion and motion can only be detected in unobstructed areas covered by

these beams. They cannot detect motion which occurs behind walls, ceil-

ings, floor, closed doors, glass partitions, glass doors or windows. Any

type of tampering whether intentional or unintentional such as masking,

painting, or spraying of any material on the lenses, mirrors, windows or

any other part of the detection system will impair its proper operation.

Passive infrared motion detectors operate by sensing changes in tempera-

ture. However their effectiveness can be reduced when the ambient tem-

perature rises near or above body temperature or if there are intentional or

unintentional sources of heat in or near the detection area. Some of these

heat sources could be heaters, radiators, stoves, barbeques, fireplaces, sun-

light, steam vents, lighting and so on.

I I I I I Warning Devices

Warning devices such as sirens, bells, horns, or strobes may not warn

people or waken someone sleeping if there is an intervening wall or door.

If warning devices are located on a different level of the residence or

premise, then it is less likely that the occupants will be alerted or awak-

ened. Audible warning devices may be interfered with by other noise

sources such as stereos, radios, televisions, air conditioners or other ap-

pliances, or passing traffic. Audible warning devices, however loud, may

not be heard by a hearing-impaired person.

I I I I I Telephone Lines

If telephone lines are used to transmit alarms, they may be out of service or busy

for certain periods of time. Also an intruder may cut the telephone line or defeat

its operation by more sophisticated means which may be difficult to detect.

I I I I I Insufficient Time

There may be circumstances when the system will operate as intended,

yet the occupants will not be protected from the emergency due to their

inability to respond to the warnings in a timely manner. If the system is

monitored, the response may not occur in time to protect the occupants

or their belongings.

I I I I I Component Failure

Although every effort has been made to make this system as reliable as

possible, the system may fail to function as intended due to the failure of

a component.

I I I I I Inadequate Testing

Most problems that would prevent an alarm system from operating as

intended can be found by regular testing and maintenance. The complete

system should be tested weekly and immediately after a break-in, an

attempted break-in, a fire, a storm, an earthquake, an accident, or any kind

of construction activity inside or outside the premises. The testing should

include all sensing devices, keypads, consoles, alarm indicating devices

and any other operational devices that are part of the system.

I I I I I Security and Insurance

Regardless of its capabilities, an alarm system is not a substitute for

property or life insurance. An alarm system also is not a substitute for

property owners, renters, or other occupants to act prudently to prevent

or minimize the harmful effects of an emergency situation.

•

Re-orient the receiving antenna

•

Relocate the alarm control with respect to the receiver

•

Move the alarm control away from the receiver

•

Connect the alarm control into a different outlet so that alarm control

and receiver are on different circuits.

If necessary, the user should consult the dealer or an experienced radio/

television technician for additional suggestions. The user may find the

following booklet prepared by the FCC helpful: "How to Identify and

Resolve Radio/Television Interference Problems". This booklet is

available from the U.S. Government Printing Office, Washington, D.C.

20402, Stock # 004-000-00345-4.

This Class B digital apparatus meets all requirements of the Canadian

interference-causing equipment regulations.