- ページ 8

セキュリティシステム DAITEM SH146AXのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DAITEM SH146AX 18 ページ。 External detector antimask

6.1 Fixing the detector in place

Fixing it ﬂat against the wall

The detector can be ﬁxed to the wall without

the bracket if it does not need any horizontal

or vertical adjustments.

1. Pre-drill the 2 blanks on the back box.

2. Fix the back box to the wall using suitable

washers and screws (not supplied).

3. Install the main unit and set the detection

range as described in the next chapter.

Fixing the angle adjustment bracket

The bracket makes it possible to adjust the horizontal angle by approximately 90 degrees.

If the ground is uneven and therefore not parallel to the base of the unit, the bracket allows

for a vertical adjustment of approximately 20 degrees.

Blanks

Screws

(not

supplied)

1. Remove the locking screw.

2. Remove the pivot protection cover by pressing

on the detector cover support with your thumb.

Use a ﬂat-headed screwdriver to remove

it if it is stuck.

Locking

screw

IMPORTANT

• Do not modify the

detection distance

with the bracket.

• Use the masking

strips to adjust the

detection distance.

Pivot protection cover

Support on detector cover