- ページ 3
セキュリティセンサー DAITEM SH274AXのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DAITEM SH274AX 4 ページ。 Contact detector
DAITEM SH274AX にも： インストレーション・マニュアル (13 ページ)
ページを印刷する1. Align the vertical slot on the magnet holder with the
arrow located on the base
of the detector.
slot-arrow alignment
IMPORTANT: the parts must be laterally aligned and their
height adjusted for the detector to operate correctly.
3. If necessary use the spacer
supplied for the magnet
holder or position a spacer
below the normally closed
detector.
Fix the magnet holder base,
place the magnet inside the
cover and clip it to the base.
To unclip the magnet holder cover, insert a small flat-headed screwdriver into the slot provided
and turn.
Overview of opening and closing distances between the
contact detector and the magnet used by the built-in
contact to analyse any change in entrance status.
5. Testing
The contact detector has a "test" mode for testing:
• the battery: the LED indicator lamp lights up when the test
button is pressed to indicate the battery is working
correctly,
• detection: the LED indicator lamp lights up when the
contact changes status,
• the radio link: see § on Checking the radio links described
in the control panel manual.
IMPORTANT: in accordance with the new functional requirements of EN50131-2-6, the LED is factory defaulted to be Inactive in
Test Mode. To change this parameter, programme:
about 10 sec.
Commence
the sequence
by pressing the test button
until the LED is off.
Max :
5 mm
35 mm
Cover
Magnet
Base
Spacers
about
2
5 sec.
Press 2 times
Press and hold and then
depending
release the test button as
on the required
soon as the LED lights for
parameter number.
the 2
nd
time.
2. Adjust the height of
the magnet holder
according to the
diagrams below.
4. Clip and then screw
the detector to its
base. Fit the screw
head plug (supplied
with the bunch of
plastic parts for the
magnet holder) to the
cover.
Built-in contact opening and closing distances
Movement
Contact
Wooden support
status
Spacing
opening
closing
Vertical
opening
34 mm
sliding
closing
20 mm
Horizontal
opening
15 mm
sliding
closing
9 mm
)
)
)
)
)
IMPORTANT: the control panel must be in installation
mode for testing.
1 or 2
Press the test 1 or 2 times to
select the required parameter.
• 1: inactive
• 2: active.
3
Max : 5 mm
Magnet holder
Detector
Spacers
Spacer
Screw cover
Soft iron support
23 mm
22 mm
11 mm
11 mm
24 mm
24 mm
19 mm
9 mm
15 mm
8 mm
12 mm
15 mm
12 mm
7 mm
8 mm
6 mm
"beep, detector X,
group Y immediate
(or delayed
or combined)"
about 10 sec.
about
2 sec.
Finish the
LED lights
programming by
for 2 seconds
pressing the test button
to confirm valid
until the led is off.
programming.