- ページ 6

ヒーター ansio 1321のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ansio 1321 13 ページ。 Oil filled radiator heater

INSTALLATION OF THE CASTER ASSEMBLY

1. Place the heater upside down as shown in the figure. To avoid

scratching the surface of the heater, it is

advisable

underneath the inverted heater.

Note: While inverting, it is possible that

you hear the oil flowing within the

appliance. This is normal and expected.

2. Connect and tighten the two-wheel

carrier plates to the body of the heater

with butterfly nuts supplied, as shown in

the figure.

3. Place the heater upright after secure installation of the wheel carrier

plates, with the wheels touching the ground.

OPERATING INSTRUCTIONS

NOTE: When the heater is working, it is normal to hear clicking noises in

the appliance. Do not be concerned or alarmed due to this.

STAND-BY MODE

The heater is in Stand-by mode while the black switch at the side of the

heater is 'ON' and the power button is 'Off'.

SAFETY PROTECTION FEATURE

If the room temperature exceeds 50 °C, all the buttons on the control panel

of the heater will be disabled. The heater beeps 10 times and displays "FF"

even if it is on the standby mode. The heater then switches OFF as a safety

feature.

Whenever the heater is set to a temperature lower than that of the room

temperature, the heater will turn ON for a few minutes and then the

thermostat sensor will turn the heater off. However, once the room

temperature falls below the set temperature, the heater turns back ON

automatically.

Connect the heater to the power supply. You will hear a beep sound. Turn

on the power switch at the side of the heater. Now, press the Power button

on the heater or on the remote.

ANSIO 1321 (M20v01)

place

soft

cloth