- ページ 11
照明器具 Anslut 011763のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Anslut 011763 12 ページ。 Lamp with motion sensor
ページを印刷する
10. Replace the battery cover.
11. Fit the product on the mounting plate and
lock in place with the screw.
FIG. 4
12. Set the required lighting-up time with
the control dial marked TIME. The time
can be set from 3 seconds to 7 minutes
(+/- 10%).
13. Use the control dial marked LUX to set
the ambient light level during which
the motion detector will switch on the
product. With the dial in position
only light up in the dark. With the dial
in position
it will also light up in the
daylight.
USE
•
The product is controlled by the ambient
light and a motion detector – the light
goes on in twilight or darkness when the
motion detector detects infrared radiation
from passing persons. The light stays on
from about 3 seconds to 7 minutes
(+/- 10%), which is set with the control
dial marked TIME.
•
The ambient light level during which the
motion detector will respond and switch
on the light can be set with the control
dial marked LUX.
NOTE:
If additional movement is detected after the
motion detector has switched on the light,
the time is reset to zero and a new time
period starts.
•
The motion detector responds to thermal
radiation (infrared radiation). At low
ambient temperatures it is therefore more
sensitive to body heat than at high
ambient temperatures.
•
Street lighting, light from buildings or
other artificial light, can affect the product
so that it does not switch on even though
it is dusk or dark. Turn the control dial LUX
to position
for the light level at which the light is
switched on. If the light switches on in
daylight, turn the control dial marked LUX
to position
which the light is switched on.
MAINTENANCE
•
Clean the lamp with a soft, slightly damp
cloth. Abrasive or corrosive detergent or
solvent must not be used.
it will
•
Clean the motion detector at regular
intervals to ensure correct functionality.
REPLACING THE BATTERY
1.
Undo the screw and remove the product
from the mounting plate.
2.
Release and remove the battery cover,
remove the old batteries and insert new
ones of the same type with the correct
polarity as shown by the markings in the
battery compartment.
3.
Replace the battery cover, fit the product
on the mounting plate and lock in place
with the screw.
to increase the upper level
to lower the light level at
EN
11