バッテリーパック FOXFURY Nomad 600-200-800のPDF 交換をオンラインで閲覧またはダウンロードできます。FOXFURY Nomad 600-200-800 2 ページ。 Battery replacement for nomad prime, p56
ページを印刷する
NOMAD
PRIME AND P56 BATTERY REPLACEMENT (P/N 600-200-800)
®
REMOVING THE BATTERY TUBES | 15 MINS
The Nomad
Prime and P56 uses six (6) Battery Tubes. Repeat the following steps
®
three (3) times in order to replace all six (6) Battery Tubes.
1
BATTERY COVER(S) ON
3
FOR P/N 200-800, 200-800-TC, 200-811/812/813/814/818/819
(APPROX)
2
BATTERY COVER
REMOVED
4
BATTERY REMOVED
Make sure the Nomad
is OFF and UNPLUGGED before starting.
®
1.
Open the Folding Tripo-Scope
1
®
locate a Battery Cover.
Use a Phillips Head ( + ) Screwdriver to remove the four (4) screws that hold the
2.
2
Battery Cover. Once the screws are removed, pull the Battery Cover off and set
it aside.
IMPORTANT: There is only one (1) Battery Tube located under each one (1)
of the Battery Covers.
Once the Battery Cover is removed, the Battery Tube is accessible. Start with the
UPPER battery first.
3
3.
At the TOP of the Battery Tube, there will be a red (positive) Battery Tube Cap.
Place an index finger on it, pull tube out by the red Cap (this should then help the
bottom portion (black Cap) of the Battery Tube to easily slide out of the Battery
Compartment). This action is similar to removing a AA battery from any generic
battery holder.
To easily remove the Battery Tube from the Nomad
straight out from the "crown" of the Red Cap.
NOTE: The wiring for the positive ( + ) and negative ( – ) Caps will remain
attached to the Nomad
Body while the Battery Tube is pulled out of the
®
Battery Compartment.
4.
Remove the Battery Tube Caps (red and black) from each end of the Battery
4
Tube. This can be done by simply popping the Battery Tube Cap off with one
thumb.
DO NOT pull the Battery Tube Caps by the wires.
REPEAT STEPS 2– 4 FOR THE 5 REMAINING BATTERIES.
Legs so they are locked and deployed. Then,
®
Body, it is best to pull