- ページ 2

キーパッド DSC PC1550のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DSC PC1550 9 ページ。 4 digit master code
DSC PC1550 にも：取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (12 ページ)

ページを印刷する

Entry Delay Off Arming

If you wish to arm your system and eliminate the entry delay, enter [

before your access code. The "Armed" light will flash as a reminder that the

system is armed and has no entry delay. An entry through any zone

programmed as a delay zone will create an instant alarm.

e.g. To arm without entry delay, press [

Disarming the System

Enter the premises only through the door(s) designated by your installer as

the entry door. Entering by any other door will sound an immediate alarm.

As soon as the entry door is opened, the keypad sounder will come on to

indicate that the system should be disarmed. Go to the keypad and enter

your four digit access code. If an error is made entering the code, press

the [#] key and enter your code again. As soon as the correct code is

entered, the "Armed" light will go out and the keypad sounder will silence.

The correct access code must be entered before the entry time expires.

The entry time delay may be changed by your installer. If an alarm

occurred during the period the system was armed, the "Memory" light and

the zone light of the zone that caused the alarm will flash for two minutes.

After the two minute period, the "Memory" light and zone light will stop

flashing and the panel will return to the ready state. Pressing the [#] key

during the two minute period will cancel the alarm memory display.

If a trouble is present when the panel is disarmed, the "Trouble" light will

come ON (See Viewing Trouble Conditions section to determine the source

of the trouble.) Note that troubles will not display while the system is in the

Alarm Memory Display Mode.

If you return home and find that an alarm has occurred while you were

away, it is possible that an intruder may still be on the premises. Go to a

neighbour's house and call the local police to investigate.

Quick Arm Feature

When the Quick-Arm feature is enabled, the system may be armed simply

by pressing [

][0] instead of the 4 digit access code. This feature allows a

person to arm but not disarm the system.

Enter [

][6][Master Code][4] to turn the Quick-Arm feature ON and OFF.

When the command is entered, the keypad buzzer will beep 3 times if

Quick-Arm is being enabled and will sound one long beep if it is being

disabled.

Press [#] to return to ready.

Door Chime Feature

The door chime feature is used, while the panel is disarmed, to provide a

tone from the keypad each time a door or window is opened or closed.

The doors and windows which will provide this indication are programmed

by your installer.

Enter [

][6][Master Code][6] to turn the door chime feature ON and OFF.

When the command is entered, the keypad buzzer will beep 3 times if the

door chime feature is being enabled, and will sound one long beep if it is

being disabled.

Press [#] to return to Ready.

][9][access code]

][9]