- ページ 14

照明器具 Foxfury Lighting Solutions 200-800のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Foxfury Lighting Solutions 200-800 20 ページ。

INSTALLING THE BATTERY TUBES | 30 MINS

Installing the Nomad

them but in reverse order.

WARNINGS

Be sure to check polarity (positive ( + ) and negative ( – )) when installing the

Battery Tubes.

Start with the bottom of the Battery Tube. Attach the black Cap to the

NEGATIVE end of the Tube. While holding the Cap in place, reinsert it into

the Battery Compartment, at an angle.

While still applying downward pressure to the Battery Tube, attach the red

Cap to the opposite POSITIVE end of the Tube. Once secure, slide the

Tube into place in the Battery Compartment.

IMPORTANT: Be sure to place the red and black wires directly

behind the Battery Tube before re-installing the Tube into the Battery

Compartment. This will prevent the wires from being damaged, and it

will help the Battery Tube go back into place easier.

Once the Battery Tube is installed, test the Nomad

ON. If it does not, check the Battery Tubes for any connection errors with

the positive ( + ) and negative ( – ) ends. Then, place the Battery Cover back

over the Battery Tube and tighten the four (4) screws into place.

Battery Tubes follows the same procedures as removing

RED CAP

(POSITIVE + )

BATTERY TUBE PLACEMENT WHILE INSTALLED

(HORIZONTAL VIEW)

BLACK CAP

(NEGATIVE – )

to make sure it turns