- ページ 3

コンピュータ・ハードウェア Daiwa RF-660のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Daiwa RF-660 4 ページ。 Speech processor

ページを印刷する

Rear View

OUTPUT LEVEL control --------.Output lead with plug:

Adjust output level

Connect to mic socked;

CC\1:

output low,

C\if:

output high.

on transceiver.

DC povJer

cord

Red: 13.5V DC Positi

Black:· DC Negative.

(vliring)

Mic. cable connection.

GND

PTT

PTT SWITCH

MIKE

GND

MICROPHONE

Fig. -1

It is necessary to check the microphone wiring before

o~erating

RF-660.

The microphone cable connection to the RF-660 is

sh01m in fig 1.

Check your microphone connector and its wiring

to ensure the. t they can be used

1:ri

th the HF-660.

If your rnic-

ronhone connector cannot be used

vri

th the RF-660 remove it and

connect the input connector to your microphone cable as sho'>·m in

Fig 1.

The output connector or the RF-66o is 2.lso '::ired as FiS'1

If it is not usable i·rit':l your Transceiver, the O''tnut connector

should be reHired to the microphone connector as shovm in the

instruction manual of the Transceiver you are using.

This

completes the Hiring.

The RF-66o is

novr

ready for operatiam.

Operation:

It is recommended that initial tests and familiarization of

the RF-66o be done with your T~nsceiver connected to a

dummy load.

Be sure the power switch of the RF-660 is in the

"OFFn

position.

Connect the microphone to RF-66o input, and the

output lead to Transceiver ·in:rmt as shown in fig

The mic-

rophone line is connected directly to the Transceiver input when

the gain control of the RF-660 is in

th~

full counter-clockwise

position.

Check the operation of the micrphone to ensure it

operates properlyJt

If it does not function properly, check

the wiring o£ the inter connection cable (see fig 1.)

Set the gain control to the full clockwise position and the

output control tn

>the

:full counter-clockwise position.

Turn