- ページ 9

コントロールパネル DSC PowerSeries PC1832のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DSC PowerSeries PC1832 20 ページ。 System enhancement module
DSC PowerSeries PC1832 にも：インストレーション・マニュアル (17 ページ), インストレーション・マニュアル (13 ページ), マニュアル (18 ページ)

ページを印刷する

STEP 6: POWER UP THE PANEL

Connect the backup battery and restore AC power to the panel.

For the SEM to interact with the existing zones on the system, it must

read them from the PowerSeries panel. The SEM will do a "zone scan" to

read this information.

The zone scan will automatically begin within one minute after the panel

is powered up and should take between 5 and 15 minutes, depending

on the number of partitions and zones on the system. Do not touch the

panel, keypad, or SEM at this time.

The zone scan is complete when the green and yellow lights on the

keypad remain solid. If you press any buttons on the keypad during the

zone scan, the message "system unavailable" will display on the screen.

The date and time will show on the screen when the zone scan

is complete.

STEP 7: BROADCAST SENSOR NAMES

For the SEM to be able to read the sensor names stored on the panel and

display them on Alarm.com, you must broadcast the sensor names stored

on the keypads. This should be done for every install with an LCD keypad

and is necessary even if there is only one keypad on the system.

ZONE SCAN

~10 minutes

Do not touch the panel or keypad.

Broadcast sensor names

by selecting the following:

[*] + [8] + [Installer Code] + [*]

to enter LCD programming.

From LCD programming,

go to field 998 and press [*]

to broadcast sensor names.