ページを印刷するTX433 for approximately 1-2 seconds to power it on. The LCD will
activate and display the primary screen.
1-4 Connecting the Speakers to the Caller
The SnowPro comes standard with 2 speakers that have 12' of cable,
and ¼" speaker jacks. Make sure your caller is turned off when
connecting the speaker cables to the speaker jacks on the sides of the
SnowPro.
1-5 Powering on the SnowPro
The SnowPro comes with an 11.1V Lithium battery pack, but you also
have the option of using an external 12-volt gel cell, SLA, or car battery
for even longer run times. If you are using the provided Lithium pack,
you will move the PWR switch to INT. If you are using an external 12-
volt battery, you will move the PWR switch to EXT. Note: In order to
use an external battery, you will need to purchase the appropriate
cable from FOXPRO.
1-6 Powering on the TX433
Turn on the TX433 transmitter by pushing and holding the power
button for approximately 1-2 seconds. Notice the black horizontal
highlight bar on the TX433 display. The bar moves up and down the
screen as you use the "Scroll Up" or "Scroll Down" arrow buttons.
2. Playing Sounds
NOTE: THE SNOWPRO TRANSMITTER IS NOT INTENDED TO OPERATE
THE CALLER AT DISTANCES SHORTER THAN 1 METER (3 FEET). IF THE
TRANSMITTER IS LOCATED TOO CLOSE TO THE CALLER, THE PROPER
OPERATION CANNOT BE ENSURED.
Power on your SnowPro caller and the TX433 as previously described.
Move the highlight bar to one of the sound categories and push the
"Select" button. Doing this results in displaying all the sounds in that
8