- ページ 3

煙警報器 DSC WS4936のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。DSC WS4936 6 ページ。 (433mhz) / (868mhz) series wireless smoke detector

ページを印刷する

"Smoke detectors shall be installed outside of each sleeping

area in the immediate vicinity of the bedrooms and on each

additional story of the family living unit, including basements

and excluding crawl spaces and unfinished attics. In new con-

struction, a smoke detector also shall be installed in each

sleeping room."

2. Mount Smoke Detector Backplate

NOTE: These alarm devices should only be installed by a

competent engineer / technician.

This device should not be used with a guard.

Once a suitable location is found, mount the detector back-

plate.

Install the mounting base on the ceiling or on the wall (if local

ordinances permit) using screw locations as required. Use

the two screws and anchors provided. Maneuver the base so

the screws are at the elbow of the screw slots and secure.

100 mm (4 in.)

minimum

100 mm (4 in.) minimum

3. Mounting

Fit the detector inside the base by aligning it over the base

(detector's alignment notch should be slightly offset from the

mounting base tamper release tab) then turn the detector

clockwise until it clicks in place.

4. Test Unit

NOTE: The central monitoring station (if used) should be noti-

fied prior to the test being generated. This will pre-

vent a false alarm and an unnecessary response

from the central monitoring station.

Initiate test by pressing the test button for 5 seconds minimum.

Alarm activation is indicated by the flashing LED, the

sounder, and transmission of the alarm signal to the control

panel. The detector restores to normal when the test button is

released.

NOTE: Allow a minimum of 20 seconds after power up and ,

after test, alarm or tamper restore activations. Do not

use test button when smoke is present.

NOTE: If the detector is in one of the following states when a

test is initiated; it will not enter an alarm state.

Tamper, (detector not installed on mounting plate)

Compensation Trouble

Other internal faults that could prevent a smoke or heat

alarm

5. Device Enrollment

The 6-digit serial number located on the back of the smoke

detector housing must be enrolled into the alarm control

panel with Installer programming. Refer to the receiver Install-

ation Manual for details. For placement tests remove detector

from backplate for one second (tamper) then reattach. Wait at

least 30 seconds for test result before activating again.

Owner's Instructions

Fire Safety In The Home

Most fires occur in the home, and to minimize this danger, it is

recommended that a household fire safety audit be con-

ducted and a family escape plan be developed.

Household Fire Safety Audit

1. Are all electrical appliances and outlets in safe con-

dition? Check for frayed cords, overloaded lighting cir-

cuits, etc. If you are uncertain about the condition of

your electrical appliances or household service, have a

professional evaluation.

2. Are all flammable liquids safely stored in closed con-

tainers, and in a cool and well ventilated area? Clean-

ing the unit with flammable liquids should be avoided.

3. Are hazardous materials (i.e., matches) out of the

reach of children?

4. Are furnaces and wood burning appliances properly

installed, clean, and in good working order? If in doubt,

have a professional evaluation.

Family Escape Planning

There is often very little time between the detection of a fire

and the time it becomes deadly. Because of this, it is very

important that a family escape plan be developed and

rehearsed.

Every family member should participate in the escape

plan.

Study the possible escape routes from each location

within the house. Since many fires occur at night, special