- ページ 3
無線アクセスポイント AirTight SS-300-AT-C-60のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AirTight SS-300-AT-C-60 4 ページ。 Access point/sensor
ページを印刷するGetting the SS-300-AT-C-60 Online
Step 1:
Power up
If using PoE, plug one end of the Ethernet cable
into the PoE switch or injector and plug the
other end into the Ethernet + PoE port
as LAN1)
on the SS-300-AT-C-60. Make sure the
PoE source you are using is turned ON.
OR
As an alternative to PoE, insert the power
adapter plug into an AC power outlet and the
other end into the power input port on the SS-
300-AT-C-60.
Warning:
If not using PoE, make sure you use only the AC power adapter that came
in the package to power up the SS-300-AT-C-60.
Step 2:
Connect to the network
If you are using PoE, then the SS-300-AT-C-60
should already be connected to your network.
If you are not using PoE, then plug one end of
the Ethernet cable into an Ethernet jack on
your network and the other end into the LAN
port
(marked as LAN1)
Warning:
Make sure you plug the Ethernet cable only into the LAN1 port and not into
the LAN2 port or into the Console port on the SS-300-AT-C-60.
Step 3:
Check the LED status
Wait for a few minutes till the four LEDs for
Power, WLAN1, WLAN2 and LAN turn GREEN,
which indicates that the SS-300-AT-C-60 is
online and operational.
(marked
on the SS-300-AT-C-60.
With PoE
Without PoE
LAN 1
LAN 2
(Ethernet + PoE)
(Reserved)
Power
WLAN1
WLAN2
LAN
Console