- ページ 8

電源 DSC ELECTRONICS DP-M SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DSC ELECTRONICS DP-M Series 16 ページ。 High power laboratorypowersupplies

DP-M Series User's Manual

Version 12.11.2021

5. Operation Instructions

Caution: Always check that the output is switched off and the capacitors are discharged before connecting the load to

the power supply. The load can be connected either after or before the power supply is switched on - but always

before the output is switched on!

5.1 Power On

1. After power on, all characters on the display meter flash for a short time (refer to fig.5-1). Then the display meter

displays the last voltage and current values set before power off for a short time (refer to fig.5-2), then the power

supply enters standby mode (refer to fig.5-3). Please do not connect any loads to the power supply during self-test.

DSC-Electronics Germany • Georgstraße 36 • 53111 Bonn

Fig.5-1

Fig.5-2

Fig.5-3