- ページ 12
カードリーダー 3MillID S-Gang Keypad ReaderのPDF マニュアルをオンラインで閲覧またはダウンロードできます。3MillID S-Gang Keypad Reader 12 ページ。 Access control reader
4.
keypad programming guide
The following instructions give a step-by-step procedure for accessing the many features
supported by this reader.
set PIN
*98
PIN CODES
*98oooonnnn#
oooo
nnnn
NOTE:
WARNING:
example
LOG OFF
*99
PIN CODES
*99#
NOTE:
example
4.
END
keypad programming guide
of
© 3millID
100-02640-A
set engineer's PIN code
Use this code to change the factory default PIN to your own
4 digit engineer's PIN setting.
.....
current PIN
(4 digits) (factory default = 1234)
.....
engineer's PIN setting
(4 digits)
Remember to keep a record of your new PIN.
If you forget your PIN setting, you will need to contact your
INSTALLER or SUPPLIER to obtain a RESET code.
To set your new PIN to 6789 enter:
the reader has been placed into programming mode.
After entering programming mode, the reader will time out
after approximately 30 seconds if no keys are pressed for
that duration. Any changes you may have made to values or
settings will be lost.
EXIT CONFIGURATION MODE
Use this code to EXIT the CONFIGURATION MODE of the
reader.
You MUST use this code to ensure any changes to values
or settings you may have made, are safely SAVED to the
reader.
Enter:
*99#
to exit CONFIGURATION MODE (and save any
settings made).
After entering programming mode, the reader will time out
after approximately 30 seconds if no keys are pressed for
that duration. Any changes you may have made to values or
settings will be lost.
The factory default PIN = 1234
*9812346789#
once
3millID 9249 S. Broadway Building #200 Suite 826 Highlands Ranch CO 80129
www.3millid.com
3M
S-Gang
Keypad
MANUAL
1
2
3
4
5
6
7
8
9
0
#
*
1
2
3
4
5
6
7
8
9
0
#
*
+1 303 475 4972
12