- ページ 3
時計 AirTime AT12RPSのPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AirTime AT12RPS 4 ページ。 Solar powered wall clock
AirTime AT12RPS にも： インストレーション＆ユーザーマニュアル (6 ページ)
ページを印刷するAirTime Solar Wall Clock
Hanging the Clock
AirTime wall clocks feature an innovative maze style mounting
bracket that prevents simple upward motion from removing
them from the wall.
1. Secure a mounting screw into the wall leaving the head
exposed.
2. Slide the clock onto the screw head at the bottom of the
maze track.
3. Move the clock down, left, down and then right until it
rests securely at the top of the bracket.
4. To remove the clock, reverse the process above.
Verifying Signal Reception
During normal operation, the clock will listen for the AirTime
signal twelve times per day on even hours, at the 58
th
th
between the 50
and 59
second. For example, the clock
listens between 10:58:50 – 10:58:59 and then between 12:58:50
– 12:58-59, continuing every even hour. The LED will not flash
Page 6
th
minute,
Doc. No. USG0080
Quick Install Steps
Important: Before installing the wall clock, verify that an
AirTime Transceiver is installed and properly transmitting. You
should manually initiate the transmission of the AirTime signal
by pressing the TRANS button on the front of your transceiver.
If an AirTime transceiver is unavailable, you can still install the
clock and set to the current time (see "Setting the Time
Manually" on page 7).
1. Insert the supplied lithium battery (CR123A) into the
battery compartment on the back of the clock.
2. Turn the clock on, by sliding the Power Switch to the Start
position.
3. Press the Reset button on the back of the clock to begin
listening for the AirTime correction signal.
4. The LED on the front of the clock will flash
two (2) seconds.
5. When the signal is received, the LED will flash
second and correction will occur. When correction is
complete, the LED will stop flashing.
Patent Pending
Installation & User's Guide
green
every
green
every
Page 3