- ページ 6

自動車アクセサリー ATS Co-PilotのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ATS Co-Pilot 12 ページ。 For dodge cummins 2003
ATS Co-Pilot にも：インストレーション・マニュアル (15 ページ), インストレーション・マニュアル (12 ページ)

10-03-12

ATS Diesel Performance

601-900-2272-INST

-Red Wire- +12V Power – PIN #1

Reasons for use: The red wire supply's key on power to the Co-Pilot so it can turn on and be

functional. NOT OPTIONAL

Locate a Power wire at the vehicles PCM. Tap the Pink/Gray wire that goes to Pin 32 of the C2

PCM Connector (PCM is located on the Passenger side firewall). This is the run/start signal.

-Black Wire- Ground (GND) – PIN #9

Reasons for use: The black wire is a constant ground which allows the Co-Pilot to turn on and be

functional. NOT OPTIONAL

Locate a Power wire at the vehicles PCM. Tap the Black wire that goes to Pin 21 of the C2 PCM

Connector (PCM is located on the Passenger side firewall).

-Orange Wire- MAP – PIN #4 (* OPTIONAL*)

Reasons for use: This function allows the Co-Pilot to sense engine load to better enhance its ability

to control the TCC application.

Locate the MAP sensor signal wire. If the vehicle has any aftermarket modifications that also tap

this MAP wire, make sure that the Co-Pilot's tap is closest to the sensor. Tap the Lt. Blue/White

Cavity A, wire that goes to the MAP sensor. MAP sensor is located on rear driver's side of engine.

-White Wire- Overdrive – PIN #5 (* OPTIONAL *)

Reason For use: This wire gives the Co-Pilot the ability to automatically cancel overdrive.

Tap the Dark Green wire that goes to Pin 13 of the C2 PCM Connector.