- ページ 11

IPアクセスコントローラ ATT Holding Kade KZ-700-U/HのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ATT Holding Kade KZ-700-U/H 12 ページ。 Integrated access controller

Integrated Access Controller – Installation manual

Change Zone 2 to Door Bell

(When no need to operate a second door, Zone 2 can be set to operate the Door Bell. The wiring is connect-

ing the door bell to COM2 and NO2. Press #, the keypad will send the signal to the door bell.

Zone 2

Door bell

To remove the alarm

To reset the Door Forced Open warning

To reset the Door Open Too Long warning

Duress User Settings

There are 10 groups Duress PIN/card available. When input Duress PIN/card, the door will open, at the

same time, the output alarm operates.

To set Duress PIN User

To add a PIN user

To delete a PIN user

To set Duress card user

To add a card user by read card

To add a card user by card number

To delete a card user

To delete All Duress users

Note that this is a dangerous option so

use with care

Note:

User ID number must be any 4digits between 2101 ~ 2110

Duress PIN/card must be unique, should be distinguished from common PIN/card

(When the Duress PIN/card is the same with common PIN/card, they will become invalid in Duress, and

worked as common user function)

Wiegand Mode Setting

KZ-700-U/H supports Wiegand 26~37, both input and output. It can be used as a reader or controller.

To Set Wiegand format:

84 0 # Factory default.

84 1 #

Read valid card or Master Code #

Close the door or Read valid card or Master Code #

1 3 user ID number # PIN #

As the same method of deleting common PIN user

(The ID number is any number between 2101~2110.)

1 3 read card 1 # read card 2 ... #

(The ID number is any number between 2101~2010.)

1 3 user ID number # card ... #

(The ID number is any number between 2101~2010.)

As the same method of deleting common card user

2 3 0000 #

9 26~37 # (Default setting: Wiegand 26)