- ページ 4

アクセサリー Attero Tech unAX4I AES67のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Attero Tech unAX4I AES67 12 ページ。 Networked audio wall plate

2 – Device Installation

Feature

4 x Mic/Lin Balanced audio inputs on XLR

Power / Status / ID LED

2 x Balanced Line outputs on De-pluggable terminal block

AES67 / Control / PoE Port

*Note: The unAX4I has a label on the front of the metal housing

at the top that shows the devices MAC address. This is important

for initial device identification as these digits make up part of the

devices default network name. The MAC address is also given on

the back of the unit.

1315 Directors Row Suite 107 Fort Wayne, IN 46808

2.1 – Mounting

A typical installation will involve mounting the wall plate into a

pre mounted wall box or mounting bracket. Before installation,

make sure the wall box where the unAX4I is to be installed is pre-

wired with a suitable cable back to a PoE-enabled network switch

or mid-span injector. If a mid-span injector is being used, the

cable should be connected to the port that supplies both Ethernet

and power (refer to the devices manual if unsure which port is

which).

Attach the network cable from the switch/mid-span injector to the

Ethernet port of the unAX4I. If the switch or mid-span injector is

already running and PoE is enabled, the unit should power up and

the green ID LED on the front of the device should turn on.

With the cable attached, carefully place the unAX4I into the wall

box taking care to not trap the cabling. Once full in place, secure

it with the screws provided. Once the unit is secured in the wall

box, fit the Decora plate and secure it with the screws provided

with it.

The figure below shows the installation of the companion passive

unXP2O XLR audio output plate and the unAX4I.

Figure 2 – unAX4I Installed with unXP2O

(Rear View)

⁞

(260)496-9668

⁞

www.atterotech.com

Page 3