- ページ 10

アクセサリー Attero Tech unDIO2x2のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Attero Tech unDIO2x2 17 ページ。 2-in/2-out dante interface
Attero Tech unDIO2x2 にも：ユーザーマニュアル (16 ページ)

ページを印刷する

1. Ip Address Setup

unDIO2x2

User Manual

3 – Device Configuration

There are two parts of the device that require software to setup. First the audio routing, and second the configurable

features of the device itself.

The audio routing should be carried out using any application that supports Dante audio routing. This could be from a

3rd party manufacturer or be Audinate's own Dante Controller. Dante Controller can be obtained from the Audinate

website (www.Audinate.com). Instructions on how to use this software and about setting up routes on a Dante network

can also be found on Audinate's website.

*Note: When using Dante controller, the unDIO2x2 will be shown using a default device name of unDIO2x2######

where '######' is the last six characters of the devices MAC address.

Configuration of the unDIO2x2 specific features is carried out using the Attero Tech unIFY Control Panel application.

This application is available from the Attero Tech website (www.atterotech.com). It should be used to examine and

modify the device specific features such as mic/line gain settings, phantom power, and output boost options.

3.1 – IP Address Setup

******************************************************* IMPORTANT ****************************************************

Failure to correctly configure IP addresses will not allow an unDIO2x2 device to correctly authenticate in the unIFY

Control Panel software and while it will show up in Dante Controller, the input and output channels won't be visible and

routing of audio to and from the unDIO2x2 will not be possible.

****************************************************************************************************************************

In order to configure an unDIO2x2 both to set up its internal parameters and also setup audio routing, the PC will need

to be able to communicate with it over the network. While all Dante devices will be discovered regardless of the IP

address setup on the PC, communication can only occur if the PC and the device have compatible IP addresses.

By default, unDIO2x2 is set to get a dynamic IP address. As with all Dante devices, if the unDIO2x2 device does not

find a DHCP server to retrieve an IP address from, it will give itself an automatic private IP address (APIPA) instead. An

APIPA is always in the range 169.254.x.y.

To ensure communication, the PC can either be set to get a dynamic IP address, or be given a static IP address in the

range 169.254.x.y. The PC may require a restart for the changes to take affect.

Further information on IP setup for an audio system using Dante can be found in the FAQ's on the Audinate website

(https://www.audinate.com/resources/faqs).

3.2 – Software Installation

After downloading the application, run the .exe and the first screen to appear will be the license agreement and options

screen.

Page 9

614-00013-05