- ページ 12
I/Oシステム Attero Tech unD3IOのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Attero Tech unD3IO 17 ページ。 2-in/2-out dante wallplate with multi-io analog connectivity
ページを印刷する3.5 – Device Identification
The device identification feature allows the user to see which device is physically being configured. When
the Identify feature is active, the power LED on the active device will flash. The Identify check box shows
the state of the device identify feature. If the box is checked, the feature is active on the active unit. If
the check box is clear, the identify feature is inactive. To change the state of the feature, simply click in the Identify
check box to toggle its state from off to on or on to off. The identify function will continue to operate until the function
is turned off via the user interface or the device is powered down.
*Note: The identify function of Dante Controller does not control the identify feature on the unD3IO. To identify a
device use the unIFY Control Panel identify function instead.
3.6 – Device Controls
Each of the unD3IO inputs has different configurable options. The balanced input on the XLR (IN 1)
has mic/line gain options, and the phantom power control. The unbalanced outputs are fed into IN2
and the user has an Input Select option to determine audio from which unbalanced connector is
used.
The mic/line gain control gives the user three gain choices depending on the type of signal being
provided to the input. For a line level signal, select the 0dB option. The remaining two options are
for use if a microphone is to be connected directly to the input. If using a microphone as an input
source, choose the gain value that best suits the microphones output signal.
The phantom power option is available for microphones that need it. The unD3IO provides 24V
phantom power. Check the box to turn phantom power on. Uncheck the box to turn it off.
The input selection option (shown right) allows the user to select which of the unbalanced inputs
are used as the second Dante output channel. Both RCA inputs are mixed by default to create
input source A. The 3.5mm stereo jack stereo inputs are mixed together to produce stereo source
B. The user can select which one of these sources the second input should be taken. The options
are source A only, source B only, or a mix of both source A and source B.
3.7 – Saving and Loading Settings
The unD3IO device settings can be saved or loaded by clicking on the
The unD3IO supports 10 internal presets with one of those presets used as the power-up default. It also supports
saving settings to, and loading settings from, a file for transferring to another device or backup purposes.
3.7.1 – Internal Presets
Settings in a device can be saved to an internal preset which can then be recalled at a later date. There are 10 internal
presets, one of which is the "Default" preset that is used to set device settings when the unD3IO is first powered on.
Select a preset to use by using the drop down in the Device Preset section. Once a preset has been selected, the
current settings of the device can be saved to the selected preset by clicking the "Save to Device" button. Alternately,
the settings from the selected preset can be loaded and used as the current settings by clicking the "Recall from Device"
button.
*Note: Loading a preset will overwrite all the current settings in the device with settings from the selected preset. The
GUI will also update to show these new settings overwriting all of its settings also.
Attero Tech LLC 2018
icon to bring up the preset form.
Page 11
unD3IO
User Manual
614-00017 Rev 05_a