- ページ 8

マイク Attero Tech Zip4のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Attero Tech Zip4 16 ページ。 Ip audio 4-button paging station

2.3 – Mounting

A typical installation will involve mounting the Zip4 wall plate into a pre-mounted wall box, wall mounting bracket, or desktop enclosure.

Before installation, make sure the wall box where the Zip4 is to be installed is pre-wired with a suitable cable back to a PoE-enabled network

switch or mid-span injector. If a mid-span injector is being used, the cable should be connected to the port that supplies both Ethernet and

power (refer to the mid-span injectors manual if unsure which port is which).

Figure 2 - In-Wall Mounting

Figure 3 - On-Wall Surface Mount (shown w/accessory box)

Figure 4 - Desktop Mount (shown w/accessory kit)

1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260) 496-9668 ⁞ www.atterotech.com

*Note: All Attero Tech products are tested using UTP cabling and

it is recommended that UTP cabling be used when installing them.

STP cabling can be used for installation though care must be taken

not to introduce grounding issues into the system by creating a

ground loop by doing so.

Attach the network cable from the switch/mid-span injector to the

Ethernet port of the Zip4. If the switch or mid-span injector is

already running and PoE is enabled, the unit should power up and

the backlight around the zone buttons should turn on.

With the cable attached, carefully place the Zip4 into the wall box

taking care to not trap the cabling. Once fully in place, secure the

front plate with the screws provided.

2.4 – Mic Hanger Options

The standard Zip4 product includes a latching metal microphone

clip. A magnetic mic solution is available as an accessory and

requires both the wired PTT with magnetic mic hanger and the

mounting plate. The mounting plate is installed by removing the

top mounting screw securing the mechanical hanger and

replacing it with the magnetic mic mounting plate.

Figure 5 – Zip4 w/ Magnetic Mic Hanger Plate

Page 8