- ページ 2
スイッチ 3onedata ICS5000-E24GP4GSのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。3onedata ICS5000-E24GP4GS 3 ページ。 Layer 2 managed industrial ethernet poe switch
ページを印刷するStep 4
Check and confirm the product is mounted firmly
on the rack, mounting ends.
【Disassembling Device】
Step 1
Power off the device.
Step 2
Adopt screw driver to loosen the 4 bolts fixed on
the mounting lugs in the rack.
Step 3
Shift out the device from rack, disassembling
ends.
Notice before power on:
Power ON operation: First insert the power supply
terminal block into the device power supply interface,
then plug the power supply plug contact and power
on.
Power OFF operation: First, remove the power plug,
then remove the wiring section of terminal block.
Please pay attention to the above operation sequence.
Please be aware of the power input range supported
by the device before powering on. Use the
recommended voltage of the device to avoid device
damage.
【Console Port Connection】
Provide 1 program debugging port based on
RS-232 serial port which can conduct device
CLI command management after connecting to
PC. The interface adopts RJ45 port, the RJ45 pin definitions
are as follows:
Pin No.
2
3
Pin
TXD
RXD
Definition
【Checking LED Indicator】
As shown above, the device provides LED indicators to
monitor the device working status with a comprehensive
simplified troubleshooting; the function of each LED is
described in the table as below:
Indicator Panel ID Status
Power
PWR
indicator
System
SYS
indicator
Ethernet
port
Link/Act
indicator
/Speed
(1-24)
SFP
interface
Link/Act
indicator
5
(25-28)
GND
Definition
The switch is not
Indicator off
powered on.
The Green
The switch is powered
light keeps on
on.
The system is not
Indicator off
started.
The system is starting
Flashing
or the system has
green
started successfully
Indicator off
Port is not Link
The orange
Port 10/100M link up
light keeps on
Flashing
Port 10/100M data
orange
transmission
The Green
Port 1000M Link Up
light keeps on
Flashing
Port 1000M data
green
transmission
Indicator off
Port is not Link
The Green
Port 1000M Link Up
light keeps on
Flashing
Port 1000M port data
green
transmission
PD is not connected to
the corresponding port
Indicator off
or PoE power is not
PoE
provided
PD is connected to the
status
PoE
The yellow
corresponding port and
indicator
light keeps on
PoE is powered
normally
(1-24)
PoE power has short
Flashing
circuit or power has
yellow
current overload
【Logging in to WEB Interface】
Support WEB management and configuration. Computer
can access the device via Ethernet interface. The way of
logging in to device's configuration interface via IE browser
is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed
Step 2
Enter device's IP address in the address bar of
the computer browser: 192.168.1.254.
Step 3
Enter device's username and password in the
login window as shown below.
Step 4
Click "Login" button to login to the WEB interface
of the device.
Note:
The
default
IP
address
"192.168.1.254".
The default user name and password of the device are
of
the
device
is