- ページ 12

コントローラー DSS NETWORKS 5161のPDF マニュアルをオンラインで閲覧またはダウンロードできます。DSS NETWORKS 5161 18 ページ。 Gigmac pmc/pci controllers

GigMAC PMC and PCI

Tuning the Installation

To try jumbo frames, the mtu size can be increased using the ifconfig utility, as

follows:

# ifconfig <interface-name> mtu <mtu-size>

eg: ifconfig eth0 mtu 3000

The BUF_SIZE_MAX value in nsm.h (Tunable parameter) should be changed to:

4096 if you enable jumbo frames.

<mtu-size> can be increased up to 4000 bytes for sane operation.

Please see the installation notes for information on functionality testing and

known driver problems.

Using dmUtil dpm driver utility

Examples:

dmUtil -s eth1

dmUtil –p eth1

dmUtil –m eth1

dmUtil –t eth1

3.3 WINDOWS DRIVER INSTALLATION

This chapter describes the installation of the GigMac in Windows 2000/98/ME

environment. Before attempting to install the software, make sure your system

settings match the system requirements listed in Chapter 1.

The Hardware Wizard in Windows 98, and the Found New Hardware Wizards of

Windows 2000 and Windows Me makes the installation processes of these

programs very similar. Before installing the GigMac driver, make sure the

hardware has been installed properly, and the adapter is connected to the

network with the appropriate network cables. For information on connecting

network cables to the GigMac Ethernet adapter, please see the "Connecting to

the GigMac" section presented earlier in this manual.

DSS NETWORKS, INC

# get driver statistics for interface 1

# get phy (transceiver) registers for interface 1

# get MAC (PCI controller) registers for interface 1

# get execution debug trace for interface1 (trace option must

be compiled in)

Version: 1.12

Controller and Driver Users Manual

Page: