- ページ 4

薪ストーブ attika ElectronicAIRのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。attika ElectronicAIR 8 ページ。

INSERTING BATTERIES IN THE REMOTE CONTROL

First, insert new batteries in the remote control.

The remote control must be in the manual setting for the remote control and the receiver to synchronise. If the remote

control is in the automatic setting, set it to manual by briefly pushing the 'up' and 'down' buttons at the same time.

SYNCHRONISATION OF THE REMOTE CONTROL AND RECEIVER

The remote control must now be synchronised using the wood-burning stove receiver. Procedure to synchronise the remote control

and receiver:

Insert batteries in the receiver.

The LED light in the front of the wood-burning stove should flash yellow and then light green. This means that the damper

is operating a start-up reference test. You may also hear a 'click' sound, which is completely normal. This process may take

up to two minutes.

After the test is finished, the LED light will flash red for 20 seconds. During this time, the remote control and receiver are

synchronised*. First, press the 'up' button and then press the 'down' button.

The LED light will briefly light green when the synchronisation is complete and then go out.

NB: Whenever the batteries are changed in the receiver, synchronisation must be repeated.

*If you did not manage to synchronise the remote control and the receiver during this time, remove the batteries and then put

them back. You can then repeat the synchronisation process.

18 - GB

Manual setting

Down

Automatic setting