- ページ 5

照明器具 DSYS DL16BWのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DSYS DL16BW 12 ページ。 Rc led lighting

Connect the KPX1 piezo buzzer instead of the

LED L2B. Set the blinking L2 while reversing

and the siren will beep intermittently.

After turning the model on the LEDs will blink and then respond to

control respectively.

Control: Stick / Wheel / Switch Position 2P / 3P Switch.

Switching ON by LED switch S1: set switch S1 to the OFF (the LEDs

are switched ON by OFF the switch).

LED L8 is permanently ON when the switch is switched ON.

Switching ON the LED with 3P switch (on the transmitter) and LED L8

control. In the down position, all LEDs are OFF. In the middle

position, L1 to L7 are ON (depending ON the setting), L8 is OFF.

Switching from middle to upper position turns ON L8 (reflector).

Control of hazard blinkers and

Move the stick to neutral and wheel straight for 1s.

Hazard blinkers LED L5 and L6: first moving wheel from straight to

left and back you turn ON blinking LEDs, second turn ON 2x flashing

LEDs, third turn OFF LEDs, other turn ON blinking LEDs etc.

Footlights

LED L7: first moving wheel from straight to right and

back you turn ON LED L7, second turn ON blinking L7, third turn OFF

L7, other turn ON L7 etc.

Switched on L5, L6, L7 can only be switched OFF when the stick is in

neutral.

L1-L7 flashes when no cables are connected or a signal failure (> 0.5s).

Only selected LEDs indicate the LED operation during setup. Test your

changes during setup.

- Insert the jumper into one connector position

1 to 6, S, W to select LEDs L1 to L6 or S

(stick), W (wheel).

- Use the jumpers in the SET connector to set

the desired properties of the selected LED, S,

- To finish the setting, remove the jumper from connector 1 to 6, S, W

and then remove the jumpers from the SET connector.

ACOUSTIC SIGNALLING

OPERATION

footlights

SETTINGS (without programming)

by steering wheel.

Select LED L2

W S 6 5 4 3 2 1

L2B