- ページ 7

医療機器 DTE S6 LEDのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DTE S6 LED 19 ページ。 Ultrasonic scaler

Num

2. Installation and adjustment

2.1 Operation

2.1.1 Open the packing box, make sure that all the parts and accessories are complete according to the packing list, take the main unit out of the

box, and put it on the the stable plane facing to the operator.In addtion,install the device to an operator-friendly position.

2.1.2 Turn the water control knob to the max according to the picture 1 direction, Do not screw it over tight in case of damage. [ note 1]

2.1.3 Insert the plug of the foot switch to its socket. (see picture 2)

2.1.4 Connect one end of the water pipe to the water entrance, and the other end to the clean water sourse. (see picture 2)

2.1.5 Before treatment, make sure scaling tip, wrench and handpiece have been sterilized. Choose the scaling tip according to the requirement,

and fix the scaling tip with the wrench. ( see picture 4)

2.1.6 Turn on the power switch, the power indicator lighted and the machine is ready for work. Touch panel is applied to this machine, power can

be adjusted by directly touching the power indicator on the touch panel.

2.1.7 Under normal working condition, the frequency of the tips is very high, light touch and a certain to-and-fro motion will eliminate the tartar

without obvious heating, overexetion and overatay are forbidden.

2.1.8 Vibrating intensity: Adjust the vibrating intensity according to your need, usually adjust to the middle grade, and adjust the vibrating during

the clinical treatment according to the patient's sensitivity and the rigidity of the tartar.

2.1.9 Step on the foot switch, the tip begins to vibrate, and the LED lamp on the top of the handpiece shines. Release the foot switch, the LED

lamp keep shining for 10 seconds.

2.1.10 Water volume adjustment: Step on the foot switch, and the tip begins to vibrate, then turn the water control switch to fine spray to cool

down the handpiece and clean the teeth.

2.1.11 The handpiece can be handled in the same gesture as a pen in hand.

2.1.12 Be sure not to make the end of the tip touch the teeth vertically, and not use too much pressure when the tip touch the surface of the teeth,

in order not to hurt the teeth and the tip.

Object

Remark

Detachable handpiece

Scaler tips

Power suplly

See picture 5

F2 food switch

See picture 6

Endochuck

Torque wrench

Endo wrench

Type No./model No./ Manufacturer/Trademark

HW-8L

ZMN-03

TD-E1

TD-1L

DTE

Guilin Woodpecker

Woodpecker

DTE